One of the great features of Ultarama™ is that you can add your own backgrounds. Here are the measurements for the back of the Ultarama™, and then below is instructions how to make pegs for your Microman / Micronaut figures.

First you will need the following materials

(2) Pliers

(1) Drill Bit size 11/64

(1) Drill Bit Chuck (for hand drilling)

(1) Box of 100 Electrical Female Disconnects 22-18 AWG .250 tab

Also Recommended (Electric Screwdriver that you can plug the Drill Bit Chuck into)

First you will need to separate the Electrical Disconnect. Take one pliers and place it on each end. Slowly twist until the metal tip separates from the plastic.

Here are the two parts separated.

Now taking the 11/64 drill bit and the drill bit chuck, you will need to drill out the peg holes in the Ultarama™ playset. You will be inserting the plastic tip of the female disconnects in these holes.

I like to insert the wider end into the figure's foot now. The wide end of the Female Disconnect is 5mm

Now Microman can hang out with his other friends.

The Micro E R It is six Ultarama stories tall. To the right are my two Bob Bases and the Build Base